For key part numbers look up the equipment serial number on the manufacturers website or consult the manual.Ĭase / International Harvester Key 1961805C1Ĭub Cadet Key MA-10253507100, MA-27800501200 and MA-11352815500 Key part numbers can change every model year and within equipment models by serial number. All key part numbers and equipment models are not listed. Please compare current key to image or key part number for equipment model to verify key. so I knew I'd never get as much out as I really wanted.Kubota #35260-31852 ignition keys, in ringed pairs keys are stamped "H32412". Then you have the hoses full of fluid, the controls with fluid. I might do another swap next summer to give currently new fluid time to work around and dilute everything that was left behind. Oil got pushed into the tank, drained all that out and refilled. I did the boom and dipper sticks like this, then went to the loader and managed to extract "a lot" of the fluid from there but I think I was more successful on the backhoe side. I then went to my controls (machine is turned off) and slowly lowered the hoe.which pushed fluid out via gravity of the side holding it up, sucking air in the other side so that when it was done, I probably had say, 90% of the oil out of that cylinder. (it's under pressure) I went to the OTHER hose that now has very little fluid on that side of cylinder and loosened it so it was open to air. I raised the backhoe, found the hose that pushed it up and left it be. I might get laid out for this comment.but I had some water in my hydraulic fluid and wanted to remove as much as I could short of pulling each cylinder off and opening them up and blowing air through the system.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |